Used a clickable sections below to skip to a specific step.

Goodyear Controller.

Initially connected is a simple process with your council turned on plug in the provided micro USB cable and connect the other end to your controller.

Press the PS button on the center of the controller.

Once the light on the back of the controller turns on, the device is connected.

You can disconnect the cable to continue playing wirelessly or keep it plugged in to charge.

If you're having issues connect, your controller hears a few methods to try.

First, the controller may not have enough Barry to connect and stay on plug in via USB to the console.

Believe it alone for 30 to 60 minutes to allow it Time to charge.

After waiting for a bit, try pressing the PS button and see if to control our backlight turns on.

If so, you can then disconnect the USB.

If you're still having issues, you'll need to reset the controller first.

Power off your PS four entirely.

Rather than using rest mode, flip your controller and look next to the L two button for a small hole that contains the reset button, take a thin paper clip and press into the slot for about five seconds, then let go with the console still off, plug into controller into the USB slot, then turned the PS four on.

Once the PS four is on, try pressing the PS button again to start the pairing process.

If successful, the backlight will turn on.

With these steps, you should be able to use your controller wirelessly with ease.

If you have any further issues, your council or controller may need hardware.

Technical support from Sony.