So the first thing we're going to do, we've got a known good harness attached here to the system and we're going to learn what that wiring pattern looks like.

So if I come up here to the software and I do a learn, it's going to go through and it's that we have attached.

This is some new technology that allows us to go back to the connectors, tie that information straight into the testers.

After it finds that, it's going to go through and scan all of these cables to learn how the whole thing is attached.

So the whole process for this cable only takes for a few seconds and we're already done.

So here we can see the screen, this is the list of all the instructions that were learned, all the wires, the connections are from two points.

From this point, we can just save the test and then we can come in here and run a test.

Again, the first thing it's going to do is go through and scan all the smart lights, figure out how the connectors are tied back to the tester.

That can change between every test and then we're ready to run a test.

That fast, it's tested the whole harness and made sure everything that's supposed to be connected is connected and that nothing that's not supposed to be connected isn't connected.

If we have an error that happens, missing a wire and we run that test again, here we can see up on the screen, it'll show us where the error is occurring.

It's between these two connectors and there's the hole that I pulled it out of and it's got that highlighted so as an operator, if I'm building the harness, I know exactly where to put the cable.

I can see the light blinking on the smart light and if I plug it right back in that hole, then it's testing good again.

So again, this is our CR product from Sirrus Systems.

You can find out more at www.sirrus.com.